Created for the American Rocketry Challenge competition rockets. A flexible foam nose cone that gives extra protection to the egg in your rocket. If the nose hits the ground first, the foam absorbs a lot of the shock, protecting the delicate egg and electronics. It also has a pocket in the base that can be used to hold the altimeter.
74mm (3-inch) TARC Foam Nose Cone
This little altimeter compartment fits into the hollow shaft located in the base of the foam nose cones that are used on TARC rockets. It holds any of
18mm Altimeter Bay for Foam Nose Cones
BT-80 TARC Parts Pack
TARC Supplies - Nose Cones - Rocketry Works
TARC Tutorial 1 - Complex Nose Cones in RockSim
This inexpensive plastic nose cone fits Mad Cow tubes and the standard size LOC (may need a little masking tape around the shoulder, if you find it a
PNC-3.00 (75mm) x 12.5
PNC-24C
56mm ARC (TARC) Foam Nose Cone [14811] - $10.65 : Apogee Rockets, Model Rocketry Excitement Starts Here
13mm Vac-Form Nose Cone
This inexpensive plastic nose cone fits the standard size LOC and Blue Tube 2.54-inch diameter body tubes. If you're a rocket designer, this is an
PNC-2.56
TARC Parts Pack for 2.2 (BT-70 size) Diameter Rockets
66mm TARC Foam Nose Cone
PNC-24D