Gtechniq HALO Flexible Film Coating 30ml – Gtechniq Singapore

4.9

(684)

Write Review

$ 45.50

Add to Cart

Qty

In stock

Description

Gtechniq HALO Flexible Film Coating enhances the performance of Paint Protection Film (PPF) and vinyl. It’s a chemically bonding, ultra-dense flexible film that becomes the permanent surface of the film – protecting it from the elements a car faces on a daily basis.
HALO enhances the performance of Paint Protection Film (PPF) and vinyl. It’s a chemically bonding, ultra-dense flexible film that becomes the permanent surface of the film – protecting it from the elements a car faces on a daily basis. The density of the coating and its low surface energy improve dirt and water repellency of PPF or vinyl. It also helps to prevent staining from dirt ingression, as well as reducing yellowing caused by UV rays. Overall, HALO keeps the PPF looking in a much better condition and makes it much easier for people to keep their car clean following PPF/ vinyl application. Rigorous real-world and laboratory testing has proven HALO to be compatible with all types of gloss, matte, and satin vinyl and PPF. It is also proven to work on self-healing films. Application Information Shake bottle well and wear gloves To apply HALO, your vehicle must be indoors and remain indoors, for at least 12 hours after the coating has been applied. For best results, good lighting is essential If applying to previously installed film, wash and decontaminate the vehicle with Gtechniq W5 Citrus All Purpose Cleaner and W6 Iron and General Fallout Remover With your surface fully cooled and dry, spray a 30% dilution of isopropyl alcohol (IPA) on to a Gtechniq MF1 ZeroR Microfibre Buff Cloth. This will remove any fingerprints or other surface contaminants ensuring you get the maximum number of chemical bonds between HALO and the film or vinyl Apply HALO evenly onto the application pad and set the bottle aside Apply with the applicator provided in overlapping strokes to an area roughly 2ft x 2ft. After coating a panel remove residue with an MF1 cloth. Always remove from further than you have applied, working from the outside in Once applied carry out a final check with an MF1 cloth and a bright but diffused light source – this will identify any excess residue left on the surface. Allow the coating to cure for at least one hour and repeat the application process so that all film and vinyl is coated with two layers of HALO An unopened bottle of HALO has a 12-month shelf life from the time of purchase Store in a cool/dry place, out of direct sunlight * Avoid direct application, paint or rubbers. *