Menzerna Super Finish 3500 (8oz)

4.9

(561)

Write Review

$ 10.99

Add to Cart

Qty

In stock

Description

Application by hand: Mist the Wolfgang German Polish N Wax Applicator with McKee’s 37 Pad Conditioner to moisten the foam. Apply a nickel size amount of Menzerna Super Finish to the applicator. Work in a back and forth, overlapping motion until the area starts to dry. Wipe off the polish with a damp Cobra Microfiber Towel. Work in 2 x 2 sq. ft. sections until the entire vehicle is done. Note: Applying Menzerna Super Finish by hand will enhance gloss but it will not remove swirls. For paint correction, you must apply this product with a polisher. Application by Machine: Make sure the surface to be polished is clean and dry. Fresh paint should be fully cured. Apply Super Finish out of direct sunlight. Use a soft foam finishing pad, like Lake Country’s CCS Gray Finishing Pad or the White Ultrafine Polishing Pad by The Edge. Apply a 6 inch line of compound to the vehicle. With the polisher turned off, spread the polish over about a 2 x 2 sq. ft. area. Polish at 1200-1800 RPM (5-6 OPM on a dual action polisher) working slowly across and then up and down the area. Check your work after several passes
Application by hand: Mist the Wolfgang German Polish N Wax Applicator with McKee’s 37 Pad Conditioner to moisten the foam. Apply a nickel size amount of Menzerna Super Finish to the applicator. Work in a back and forth, overlapping motion until the area starts to dry. Wipe off the polish with a damp Cobra Microfiber Towel. Work in 2 x 2 sq. ft. sections until the entire vehicle is done. Note: Applying Menzerna Super Finish by hand will enhance gloss but it will not remove swirls. For paint correction, you must apply this product with a polisher. Application by Machine: Make sure the surface to be polished is clean and dry. Fresh paint should be fully cured. Apply Super Finish out of direct sunlight. Use a soft foam finishing pad, like Lake Country’s CCS Gray Finishing Pad or the White Ultrafine Polishing Pad by The Edge. Apply a 6 inch line of compound to the vehicle. With the polisher turned off, spread the polish over about a 2 x 2 sq. ft. area. Polish at 1200-1800 RPM (5-6 OPM on a dual action polisher) working slowly across and then up and down the area. Check your work after several passes to see if the defects have been removed. If so, reduce the pressure and continue buffing until a high gloss is achieved. If the pad becomes dry, mist it with water and continue buffing. Wipe the area with a damp microfiber cloth. Always apply a wax or sealant after polishing.