Sculpfun S9 Laser Cutter: Support for motorized Z-axis with BL Touch probing sensor in Lightburn? - LightBurn Hardware Compatibility - LightBurn Software Forum

I recently purchased a Sculpfun S9 Laser Cutter along with Lightburn. As the Laser head has a fixed focus I’m looking into options for a motorized Z-axis with touch probe. I came across this Thingiverse item, which uses the BL touch sensor. The Sculpfun uses an XY DLC v1.0 controller board, which has both connectors for a Z motor as well as a probe: So the question is: Can Lightburn control the Z motor and BL touch sensor combination? The interesting/tricky bit is that the BL touch has a

Setting Up The Software – sculpfun

Laser stays at full power (fire) new 3000mw blue just set up

Setting Up The Software – sculpfun

Y-Axis is flipped (Sculpfun S9) - LightBurn Software Questions

SCULPFUN S30 Pro 10W Laser Engraver with Automatic Air-assist

Machine advice for compatibility - LightBurn Hardware

SCULPFUN S30 Laser Engraver with Auto Air Assist Pump

Lightburn can't find my Sculpfun S9 after update - LightBurn

Lightburn can't find my Sculpfun S9 after update - LightBurn

Lightburn can't find my Sculpfun S9 after update - LightBurn

Buy SCULPFUN S30 Ultra 33W/22W Laser Engraver Module Head Kit Air Assist Pump XY Limit Switch for S9/S30/S30Pro/S30Pro Max Upgrade at Aliexpress for .

SCULPFUN S30 Ultra 33W/22W Laser Engraver Module Head Kit Air Assist Pump XY Limit Switch for S9/S30/S30Pro/S30Pro Max Upgrade

Connection solution for Sculpfun S9 laser to Mach3 MKV-4 board