Tru Blu Test Strips Sodium Bromide Genesis Isis Pioneer True Blue

(154)

Write Review

$ 7.50

Add to Cart

Qty

In stock

Description

Tru Blu test strips BW-T600 are specifically made to test sodium bromide in hot tubsthat use Genesis and Blu Fusion (Isis) by Pioneer H2O bromine salt generators. Get your hot tub chemical test strips at Hot Tub Outpost.
Bottle of Tru Blu Test Strips T100 to test for Sodium Bromide (Does not test for Bromine) TEST STRIPS for Sodium Bromide (NaBr) Genesis Salt System Fill a small glass with one inch of spa water. Insert lower end of strip into water. IMPORTANT: Keep top half of strip completely dry to get an accurate reading. Yellow band will turn dark when test is complete (it should take 3-4 minutes). A reading of between 1,900 and 2,100 ppm is recommended. Pioneer H2O Tru Blu Test Strips - Sodium Bromide (NaBr) Why do we need sodium bromide test strips when using a Genesis/Isis bromine salt generator? Because over time water is splashed out, evaporates, is removed by exiting bathers etc.., so we need to monitor the sodium bromide level (not bromine level) to assure there is enough available bromine salt for the system. Use these bromine salt test strips to determine how much sodium bromide (Tru-Blu) to add. You will need a bottle or two of Sodium Bromide to top up low levels and to establish a reserve level when refilling the spa, or to top up the available bromine salt in the spa. Use these bromine salt test strips and not regular bromine test strips. Do not fill the spa from a water softener. The manufacturer recommends balancing the water when refilling with these levels: pH: 7.2 - 7.8 Total alkalinity: 80 - 120 PPM – mg/l Calcium hardness: 150 - 200 PPM – mg/l Phosphate level less than 125 PPB 98% Sodium Bromide NaBr Follow the instructions that came with the bromine salt generator. Note that on a new spa refill, it can take several days for bromine level to stabilize. Press the Boost button on the system for the occasional heavy bather load. If the water source when refilling the spa has high total disolved solid content, it is best to use a pre-filter that attaches to the garden hose to filter out chemical and organic contaminants and start off fresh. The Tru Blu Sodium Bromide level in your spa should be between 1500 – 1900 ppm. Check the chart on your bottle of Tru-Blu Test Strips. The reading should fall between 7.6 and 8.0. Tru Blu T-100 Salt Test Strips also replaces 562053 , NABRTS , T100

PRODUCT DESCRIPTION, TRU BLU is 99% pure Sodium Bromide (NaBr) and comes from Be’er Sheva, Israel on the Dead Sea. This natural salt is added to your