Can't cut all the way through 3mm basswood (likely user error) - LightBurn Software Questions - LightBurn Software Forum

I’m guessing I am doing something wrong here. I have a Gweike Cloud 50 watt laser. From what I have read, the model I have (newest release) is more powerful then previous releases (which were good cutters). I import the outline of a shape into Lightburn as a png. I “traced” it into a vector. Even setting 100% power at a slow rate, it does not go all the way through 3mm basswood. The attached image shows the back of the cut. What could make it do this instead of cutting through? The resul

How to use Gweike Cloud with LightBurn + tips, tricks & FAQ - Gweike & Gweike Cloud - LightBurn Software Forum

Not cutting through 1/8 basswood - LightBurn Hardware Compatibility - LightBurn Software Forum

Laser Is Not Cutting Through The Entire Project - Ortur Lasers - LightBurn Software Forum

Ortur Master 3 error message - LightBurn Software Questions - LightBurn Software Forum

Cutting error on 3mm Acrylic - LightBurn Software Questions - LightBurn Software Forum

Inconsistent cuts in MDF - Community Laser Talk - LightBurn Software Forum

Trouble cutting 3mm ply - Tips and Tricks - LightBurn Software Forum

Struggling with a cut on 3mm Birch - Tips and Tricks - LightBurn Software Forum

Inconsistent cuts in MDF - Community Laser Talk - LightBurn Software Forum

Trouble cutting 3mm ply - Tips and Tricks - LightBurn Software Forum

Edit Node - Trim behavior - LightBurn Software Questions - LightBurn Software Forum

How to use the Lightburn Material Test card with YOUR BASELINE SETTINGS. Full demonstration!

Files dxf problem - LightBurn Software Questions - LightBurn Software Forum

Not cutting through 1/8 basswood - LightBurn Hardware Compatibility - LightBurn Software Forum